PogoSaver AXS Compact — Housing only

Overview

A reduced-footprint 3D-printed housing for building a PogoSaver battery-contact bridge on compatible SRAM AXS rear derailleurs with tighter fairing clearance. The Compact version uses a separately sourced zip tie instead of the larger latch used by the original PogoSaver housing.

Key Features

• Compact body intended for tighter clearance around the battery area.
• Designed to be retained with a separately sourced zip tie.
• Available in the selected red or black colour.
• No drilling or permanent derailleur modification is intended.

Included — Printed Housing Only

• 1 × 3D-printed PogoSaver AXS body in the selected colour

Required Parts for “Printed Housing Only”

The printed housing alone does not create an electrical connection. Additional compatible components and correct assembly are required.

The “Printed housing only — hardware not included” option contains only the 3D-printed body. To assemble a working PogoSaver, you must separately obtain compatible 11.5 mm spring-loaded pogo pins and one 15 mm OD × 13 mm ID × 1 mm nitrile-rubber O-ring.

• 11.5 mm spring-loaded pogo pins on Amazon
• 15 mm OD × 13 mm ID × 1 mm nitrile O-ring on Amazon

These third-party links are provided only to help identify compatible components. The linked products are sold by third parties and are not sold by, included with, or warranted by VeloLayers. Sellers, prices and availability can change. Check the dimensions before ordering.

Compatibility

Designed for these SRAM AXS rear derailleurs where the Compact housing and zip-tie arrangement have adequate clearance:

• SRAM XX1 Eagle AXS
• SRAM X01 Eagle AXS
• SRAM GX Eagle AXS
• SRAM RED AXS
• SRAM Force AXS
• SRAM Rival eTap AXS

Not designed for AXS rear derailleurs using a UDH mount. Component revisions and individual setups can vary; compare the battery area with the product photos or contact VeloLayers before ordering.

Materials and Finish

• Manufacturing method: 3D printing
• Mounting method: separately sourced zip tie
• Colours: red or black

Fine layer lines and small surface variations are normal characteristics of 3D printing.

Installation and Safety

This is an accessory component, not a diagnosis or guaranteed repair for every battery-contact problem. Confirm the fault before installation. Assembly requires suitable electrical-contact components and careful alignment. Ensure the battery is fully retained and the housing cannot move into other components. Test operation in a safe location before riding and stop use if power remains intermittent, the battery is loose or the housing is damaged. Follow SRAM instructions and seek a qualified bicycle technician if unsure.

Production and Delivery

This item is made to order. Hong Kong orders are produced in Hong Kong; eligible US orders may be printed and dispatched by Slant 3D. Fulfilment location does not change the selected package contents.

Independent Accessory Notice

SRAM and AXS are trademarks of their respective owners and are referenced only to describe compatibility. PogoSaver is an independently designed VeloLayers accessory. It is not manufactured, sponsored, endorsed, approved or warranted by SRAM, and VeloLayers is not affiliated with SRAM.